Installing A New Dishwasher Without a Plumber

When it comes to installing a new dishwasher, you need not to hire a plumber for this. It is very easy and you can do it yourself. You just have to follow the following steps.

However, before you start, make sure the following tools are available to you, as you will need them in the process.

Tools
Screwdriver
Multimeter
Slip-joint pliers
Needle-nose pliers
Adjustable wrench

Note: If you are replacing an old dishwasher, you must buy a same size new dishwasher.

Installation Process
The following steps will let you know how you can install a new dishwasher. We have assumed that you are replacing an old dishwasher with a new one. Therefore, the procedure starts from removing the old dishwasher first and then installing the new one.

1. Turn off the water supply at the valve.
2. At the electrical service panel, switch off the power for the dishwasher.
3. At the top of the dishwasher counter flange, you will find some screws. Unscrew them with the screwdriver to remove them.
4. Now pull out the bottom cover.
5. Be very careful. Make sure that you have turned off the power. Open the electrical box to confirm the same. You can do it by attaching the black multimeter contact to the ground and then touching the red contact to the white wire and the black wire.
6. At the end of the wires, attach wire nuts. Now remove the wires from the terminal screws and tuck them out of the way.
7. Find out where is the water supply under the washer.
8. Disconnect the water supply line from the water inlet by removing the nut.
9. Loosen the clamp and remove the hose to disconnect the drain hose from beneath the sink.
10. After disconnecting all the attachments, place a blanket in front of the dishwasher, slowly lift up the dishwasher and put it onto the blanket.
11. Keep a towel ready with you because in this process of lifting up the dishwasher and putting it onto the blanket, some water may spill out. If it happens, just wipe it with the towel.
12. Now that you have removed the old dishwasher, clean the area where the old dishwasher was placed and where you have to install the new one.
13. Position the new dishwasher on its back.
14. Connect the drain hose with a compression clamp.
15. Wrap the water line connection with Teflon tape and attach the 90-degree brass fitting that is used to connect the water line, also known as dishwasher 90.
16. Adjust the front legs of the new dishwasher downward so that you can easily slide the unit into place. Meanwhile, with the help of an assistant, slide the drain hose also under the sink.
17. Connect the water line underneath the dishwasher to the dishwasher 90.
18. Pass the electric cable through the sleeve on the dishwasher and tighten the same so that the cable could not be pulled out.
19. Now make all the connections of the wire: ground wire to the green screw, white wire to white wire, and black wire to black wire. Use wire nuts to secure the connection.
20. Connect the new drain hose at its previous position.
21. Fill the water line by opening the hot water valve.
22. Carefully examine if there is any leaks.
23. If any leaks occur, recheck all the connections and test again.
24. Once you are sure that there is no leaks or problem as such, go ahead.
25. Adjust front legs of the dishwasher and position it properly on a level.
26. Drive the small mounting screws into the underside of the countertop through the flange in order to attach the dishwasher to the countertop.
27. Reconnect the water supply line.
28. Turn on the power and your dishwasher is ready to act.

Hence, if you follow the above steps, you can easily install your new dishwasher yourself. However, you need to be very careful especially while making the electric connections. Make sure that you have turned off the electric power.

Information and Articles: http://www.mastersmba.com

Providing Information on various topics such as Installing A New Dishwasher Without a Plumber, please browse our other Articles for more informative resources, we house information on every topic imaginable so regardless of your needs you can be assured to find the answer here. If you wish to reprint this on your own website, simply click the "Web Version" in the right menu, and you are presented with a pre-formatted document to use.

A lot of the information is written by the Master Article team, and published exclusively on the MastersMBA.com website, and we do our best to research all information to ensure it's as accurate as possible. However at times we also publish documents given to us by other sources, we do examine these documents to ensure they are as accurate and correct as possible however at times they discuss highly specialized fields making it hard to authenticate the validity of every fact in the document. These are written by specialists in their respective fields, and we do trust their integrity and judgment however it's always a good idea when doing any research to consult a number of sources and form your own conclusion based on a number of view points. Installing A New Dishwasher Without a Plumber